The Problems for the IYPT 2012 as published on IYPT.org:
A sequence of identical steel balls includes a strong magnet and lies in a nonmagnetic channel. Another steel ball is rolled towards them and collides with the end ball. The ball at the opposite end of the sequence is ejected at a surprisingly high velocity. Optimize the magnet’s position for the greatest effect.
When a piece of thread (e.g., nylon) is whirled around with a small mass attached to its free end, a distinct noise is emitted. Study the origin of this noise and the relevant parameters.
A long string of beads is released from a beaker by pulling a sufficiently long part of the chain over the edge of the beaker. Due to gravity the speed of the string increases. At a certain moment the string no longer touches the edge of the beaker (see picture). Investigate and explain the phenomenon.
If a high voltage is applied to a fluid (e.g. deionized water) in two beakers, which are in contact, a fluid bridge may be formed. Investigate the phenomenon. (High voltages must only be used under appropriate supervision – check local rules.)
Illuminate a water tank. When there are waves on the water surface, you can see bright and dark patterns on the bottom of the tank. Study the relation between the waves and the pattern.
A woodpecker toy (see picture) exhibits an oscillatory motion. Investigate and explain the motion of the toy.
A drawing pin (thumbtack) floating on the surface of water near another floating object is subject to an attractive force. Investigate and explain the phenomenon. Is it possible to achieve a repulsive force by a similar mechanism?
Is it possible to float on water when there are a large number of bubbles present? Study how the buoyancy of an object depends on the presence of bubbles.
Place a coin vertically on a magnet. Incline the coin relative to the magnet and then release it. The coin may fall down onto the magnet or revert to its vertical position. Study and explain the coin’s motion.
Fill a bottle with some liquid. Lay it down on a horizontal surface and give it a push. The bottle may first move forward and then oscillate before it comes to rest. Investigate the bottle’s motion.
Fill a thin gap between two large transparent horizontal parallel plates with a liquid and make a little hole in the centre of one of the plates. Investigate the flow in such a cell, if a different liquid is injected through the hole.
Paper lanterns float using a candle. Design and make a lantern powered by a single tea-light that takes the shortest time (from lighting the candle) to float up a vertical height of 2.5m. Investigate the influence of the relevant parameters. (Please take care not to create a risk of fire!)
Breathe on a cold glass surface so that water vapour condenses on it. Look at a white lamp through the misted glass and you will see coloured rings appear outside a central fuzzy white spot. Explain the phenomenon.
If a steel ball is dropped onto a bed of dry sand, a “splash” will be observed that may be followed by the ejection of a vertical column of sand. Reproduce and explain this phenomenon.
It often happens that a golf ball escapes from the hole an instant after it has been putted into it. Explain this phenomenon and investigate the conditions under which it can be observed.
A vertical tube is filled with a viscous fluid. On the bottom of the tube, there is a large air bubble. Study the bubble rising from the bottom to the surface.
A small, light ball is placed inside soap foam. The size of the ball should be comparable to the size of the foam bubbles. Investigate the ball’s motion as a function of the relevant parameters.
Picture “Woodpecker toy” © Mike Willshaw – http://www.flickr.com/photos/freakdog/308938937/
Picture “String of beads” © Hans Jordens and Leonid Markovich